- May 7, 2015
- 5
- 0
- 4,510
Hi All,
This is my first time building a computer. I have carefully watch guides on how to build one and followed them very close. I have built my system, and connected it to a monitor. When I turn on the system, I noticed that the CPU_LED is lit, and the monitor says "VGA: No Signal". I've read through many of the posts in this forum, and have seen that a common issue is that they forget the connected the power to the CPU. I checked, and confirmed that I have it connected. I have also taken out the CPU and checked if there was any bent pins, and there weren't any. I was wondering if any of you could help me with this. Thanks.
Specs:
Motherboard: ASUS M5A99FX Pro R2.0
RAM: Corsair Vengeance (2 x 4GB) DDR3 1600MHz
CPU: AMD FX6300
GPU: EVGA Geforce GTX 750Ti SC
Optical Drive: Asus 24x DVD-RW
PSU: Corsair Builder Series CX 500W 80+
HDD:WD Blue 1TB SATA 6GB/s 7200 RPM
This is my first time building a computer. I have carefully watch guides on how to build one and followed them very close. I have built my system, and connected it to a monitor. When I turn on the system, I noticed that the CPU_LED is lit, and the monitor says "VGA: No Signal". I've read through many of the posts in this forum, and have seen that a common issue is that they forget the connected the power to the CPU. I checked, and confirmed that I have it connected. I have also taken out the CPU and checked if there was any bent pins, and there weren't any. I was wondering if any of you could help me with this. Thanks.
Specs:
Motherboard: ASUS M5A99FX Pro R2.0
RAM: Corsair Vengeance (2 x 4GB) DDR3 1600MHz
CPU: AMD FX6300
GPU: EVGA Geforce GTX 750Ti SC
Optical Drive: Asus 24x DVD-RW
PSU: Corsair Builder Series CX 500W 80+
HDD:WD Blue 1TB SATA 6GB/s 7200 RPM
Facebook
Twitter
Instagram