Hi everyone!
I really hope you can help me because I'm pulling my hair out! (NOT LITERALLY)
I've been building a gaming PC and everything was going smoothly until I installed
my GPU water cooling system..
I had a local electrical repair man remove the stock cooler and install the waterblock (FC Titan), so I set everything up correctly, installed the card and tried to boot the system but it kept going to windowed mode and crashing when trying to boot... finally i had to reinstall windows but since id just installed win8.1 I wasn't bothered. It started up but in windowed mode and crash
I took the card apart to see what the issue could be and found the electrical guy hadn't covered them all properly, covering some that didnt need to be covered and because of this the heat sink wasn't even making contact but i seemingly sorted and there was contact but my problem remains?
this watercooling system
http://www.watercoolinguk.co.uk/p/Magicool-DIY-Water-Cooling-Set-Single-120-mm-Edition_50412.html
with this block or very similar
http://www.ekwb.com/shop/ek-fc-titan.html
without installing the drivers i cant see if its overheating.. the pump and everything is working
great.
I did install another card without water cooling but with pump on to see if it was a power issue but it worked fine.
any ideas?
sorry for any bad grammar lol
I really hope you can help me because I'm pulling my hair out! (NOT LITERALLY)
I've been building a gaming PC and everything was going smoothly until I installed
my GPU water cooling system..
I had a local electrical repair man remove the stock cooler and install the waterblock (FC Titan), so I set everything up correctly, installed the card and tried to boot the system but it kept going to windowed mode and crashing when trying to boot... finally i had to reinstall windows but since id just installed win8.1 I wasn't bothered. It started up but in windowed mode and crash
I took the card apart to see what the issue could be and found the electrical guy hadn't covered them all properly, covering some that didnt need to be covered and because of this the heat sink wasn't even making contact but i seemingly sorted and there was contact but my problem remains?
this watercooling system
http://www.watercoolinguk.co.uk/p/Magicool-DIY-Water-Cooling-Set-Single-120-mm-Edition_50412.html
with this block or very similar
http://www.ekwb.com/shop/ek-fc-titan.html
without installing the drivers i cant see if its overheating.. the pump and everything is working
great.
I did install another card without water cooling but with pump on to see if it was a power issue but it worked fine.
any ideas?
sorry for any bad grammar lol