Using two dual channel ram sets at different sizes and voltage?

Toggle sidebar Toggle sidebar
A

Alexx2208

Reputable
May 23, 2015
10
0
4,510
Hey guys

I have a set of 2x4gb hyperx genesis 1866mhz at 1.65v, and a new set of hyperx fury 2x8gb 1866mhz at 1.5v. I'm wondering if it's ok to put the all in the system. I tried, and the display did not start. So there was some sort of problem. I removed the genesis', and it booted with a could not overclock message... So there's a problem there..

Any ideas would be appreciated.

A
 
Solution
Tradesman1
DOubt if they will work together, probably not even with manual setup (they migth), but the Genesis works off XMP and uses weaker memory chips (hence needs the higher - 1.65 - voltage and the FUry operate off PnP, they set themselves up and set up to run as fast as they can at 1.5....it would prob be possible at 1333 maybe 1600, but could also take a long time to figure out a timing and voltages combos
Sort by date Sort by votes
Tradesman1

Tradesman1

Legenda in Aeternum
Jun 5, 2013
67,883
40
126,960
DOubt if they will work together, probably not even with manual setup (they migth), but the Genesis works off XMP and uses weaker memory chips (hence needs the higher - 1.65 - voltage and the FUry operate off PnP, they set themselves up and set up to run as fast as they can at 1.5....it would prob be possible at 1333 maybe 1600, but could also take a long time to figure out a timing and voltages combos
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom