Hi I recently installed a new motherboard to my computer because my previous MB (GA-78LMT-SP2) had a RAM slot go south I have swapped all the hardware from this board over to the new MB (except I got some shiny new G-Skill RAM boards 2x8 GB 1600 (I haven't overclocked the RAM yet it's still at 1333 Mhz ). I couldn't update the drivers from the supplied disk, so I thought I'd re-install windows and start from scratch. On re-installing windows I followed the instructions as per the manual, to the part which says 'load drivers' so after finding out how to do this (after installing windows). I re-installed it to go through the repair option to get to the load driver button... I then browsed to the appropriate location to get to the drivers, but it gave the message, 'The specified location does not contain information about your hardware' So, I then found a couple of posts suggesting to enter command prompt, DISKPART, SELECT DISK 0, CLEAN, EXIT EXIT. This worked (If your reading this looking for a hard disk not found issue I think this is probably the fix your after) in so much it cleaned my hard drive, so I then clicked the 'load driver' button again, went to the drivers only this time it does'nt let me select the file, only the folder. Now it states that 'No device drivers were found, make sure that the installation media contains the correct drivers, and then click OK' So I'm not really sure what I need to do from here, any help would be greatly appreciated!!