Windows 7 Home Premium Chkdsk /f C: issue

Toggle sidebar Toggle sidebar
K

K7ibanez

Distinguished
Aug 10, 2011
9
0
18,520
I had closed my laptop earlier in the day, came back a few hours later and when I did iTunes would not open so I chose to reboot my PC. After it reboot, it just loaded into windows and froze, shortly after it flashed a BSOD and when it reset again it said bootmgr missing. I put in my windows disk and repaired and I am now back on the laptop but when I run a "chkdsk /f C:" I still get errors and it tells me to schedule a repair when I reboot. When I reboot, it cancels the chkdsk immediately. The screen is only available for a brief second. I was able to get a picture with my phone of the screen and it shows it canceled the fix. I also want to add that no dump file was created for the BSOD.
http://i.imgur.com/oOhuGYm.jpg
oOhuGYm.jpg


Below I have pasted a current chkdsk run.


C:\Windows\system32>chkdsk C:
The type of the file system is NTFS.
Volume label is OS_Install.

WARNING! F parameter not specified.
Running CHKDSK in read-only mode.

CHKDSK is verifying files (stage 1 of 3)...
200448 file records processed.
File verification completed.
524 large file records processed.
0 bad file records processed.
0 EA records processed.
47 reparse records processed.
CHKDSK is verifying indexes (stage 2 of 3)...
275984 index entries processed.
Index verification completed.
0 unindexed files scanned.
0 unindexed files recovered.
CHKDSK is verifying security descriptors (stage 3 of 3)...
200448 file SDs/SIDs processed.
Security descriptor verification completed.
37769 data files processed.
CHKDSK is verifying Usn Journal...
35409160 USN bytes processed.
Usn Journal verification completed.
The master file table's (MFT) BITMAP attribute is incorrect.
The Volume Bitmap is incorrect.
Windows found problems with the file system.
Run CHKDSK with the /F (fix) option to correct these.

124930047 KB total disk space.
82854144 KB in 147687 files.
114360 KB in 37770 indexes.
0 KB in bad sectors.
306203 KB in use by the system.
65536 KB occupied by the log file.
41655340 KB available on disk.

4096 bytes in each allocation unit.
31232511 total allocation units on disk.
10413835 allocation units available on disk.
 
Solution
K
Sort by date Sort by votes
S

skitszo

Honorable
Jul 6, 2015
934
1
11,365
see if you can get your data off.... it may be you'll need a new install..... check your hard drive with Hard Disk Sentinel and do a "short self-test".

closing down a computer before it configures an update has lethal OS issues more then you would think.
 
Upvote 0 Downvote
K

K7ibanez

Distinguished
Aug 10, 2011
9
0
18,520


I have all windows updates disabled, and as far as I know, nothing was running at the time of closing. I have also backed up everything.

Hard Disk Sentinel reports my C drive (SSD) life at 77%

Here is the results.

11 errors occured during data transfer. This may indicate problem of the device or with data/power cables. It is recommended to examine and replace the cables if possible.
13 errors reported during write to the device.
At this point, warranty replacement of the disk is not yet possible, only if the health drops further.
It is recommended to examine the log of the disk regularly. All new problems found will be logged there.
The TRIM feature of the SSD is supported and enabled for optimal performance.

The question now is do I buy a new SSD or do I just reinstall Windows?
 
Upvote 0 Downvote
S

skitszo

Honorable
Jul 6, 2015
934
1
11,365
With OS corruption you have to think its either from a virus; bad memory; hard drive going bad. You want to rule out hardware issues before you go thru the trouble of taking the time to do software trouble shooting.

I'd make sure the hard drive is good(which you did). to be honest i've never seen a SSD partially go bad so if its already starting then i'd say replace it. Weird to me. Hard disks have partial badness and it just closes out bad sectors on the disk itself and you lose disk space but it works fine. SSD's aren't like that.

Memtest your memory. If its throwing out a bunch of errors it will corrupt windows.

Others will also advice you to get a known good PSU from tier 1 or 2 on the list here at tomshardware.

If you rule out mechanical then your good to go with software trouble shooting..... to be honest its easier and faster in the long run to just do fresh OS installs. If you have a virus running around corrupting windows there's no telling how deep the damage goes. If you have time on your hands just want to learn odd procedures for fixing windows well have at it; if you don't want to mess around just fresh install.

Belarc - document your program licenses and copy to flash drive(if you can)

if you can see the contents of your data using another rig use a copying program.-- Richcopy 4.0 was cool to use for me. Teracopy also is good for some.

 
Upvote 0 Downvote
K

K7ibanez

Distinguished
Aug 10, 2011
9
0
18,520


Just a few minutes ago I walked in to see my laptop saying I need a repair disk again and now Hard Disk Sentinel is showing the life down to 73% from 77% and the number of errors has increased. I have always been active on scanning my laptop and have never had a virus on it. I'm pretty sure it is the SSD.

Did one pass of memtest so far and no errors. Going to run it all night and see how that turns out in the morning.


Ran memtest all night for 5 passes in total and had 0 errors.
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom