So I got this keyboard on July 14th 2015 and I fell in love from using it right off the bat.
The escape key however was.. inconsistent, I noticed that it not only needed to pressed down to the very bottom, which is unusual for a cherry mx red switch which actuates halfway. It needed quite a bit of force even when it was already touching the bottom.
I knew that this wasn't normal since for a few minutes it would act normal then act all junk.
So is there a possible way for this to fix for myself. Maybe I could take off the individual housing and inspect for myself, or can I only take off the entire backplate to fix. if that is the case I will probably just leave it like that.
Leave any suggestions
EDIT: This is the RED LED version if that matters
The escape key however was.. inconsistent, I noticed that it not only needed to pressed down to the very bottom, which is unusual for a cherry mx red switch which actuates halfway. It needed quite a bit of force even when it was already touching the bottom.
I knew that this wasn't normal since for a few minutes it would act normal then act all junk.
So is there a possible way for this to fix for myself. Maybe I could take off the individual housing and inspect for myself, or can I only take off the entire backplate to fix. if that is the case I will probably just leave it like that.
Leave any suggestions
EDIT: This is the RED LED version if that matters
Facebook
Twitter
Instagram