I am reusing a Jeantech JNP-700-A12C power supply from my last build.
Z97 MB with Intel i3 (4160), 2 X 8GB HyperX DDR3 - 1600, Crucial 500GB m2 SATA SSD.
Installed the above components and only attached the ATX Power supply 20 + 4 connector.
When switching on, fan twitches, display presents 00 which book says check cpu installation. 100% sure CPU is inserted correct (triangle inserted to bottom left corner - checked 3 times) and wonder if this is a power issue.
Any help greatly appreciated
Z97 MB with Intel i3 (4160), 2 X 8GB HyperX DDR3 - 1600, Crucial 500GB m2 SATA SSD.
Installed the above components and only attached the ATX Power supply 20 + 4 connector.
When switching on, fan twitches, display presents 00 which book says check cpu installation. 100% sure CPU is inserted correct (triangle inserted to bottom left corner - checked 3 times) and wonder if this is a power issue.
Any help greatly appreciated