Any suggests on where/how to put an old ten pin card reader on this board? Just put in usb spot will work?http://m.newegg.co

[roosterwes]

Trying to connect a card reader to MSI Z97S Krait Edition. An older 10 pin one.

 

[joex444]

On the lower left hand corner of the board there's JUSB1 and JUSB2 labeled with "USB" overlaid through the pins. You say 10 pins referring to a USB 2.0 header, and 9 pins actually exist; your device should actually only have 9 holes on it to prevent you from putting it on backwards (particularly important as that would swap +5V and GND).