Ive got a computer hooked to my PlasmaCam table, which is basically a CNC table with a plasma torch that cuts out designs, parts, or whatever you like from steel. The table has a control box on it and a parallel chord connecting to the computer I built. I used an MSI Krait Edition X79 board, and mounted an Nvidia graphics card in support of CAD programs, and I used a Sunix PCIe parallel card (single) for the parallel cable. I installed the drivers just like it said and all looks good in device mgr. However, I cant get it to recognize the machine through the software. Does the settings for parallel port in bios have anything to do with this? I have cut it off and on trying to get it to read. Also, what speed should i set the PCIe lane at? Also, any other ideas? Thx in advance. This board has been good to me in the past.
WES
WES