I have recently built a PC for the first time and i'm using a maximus vii ranger mobo. I purchased HyperX FURY Series 8GB (2x 4GB) DDR3 1866MHz CL10 DIMM Memory Module Kit and when putting them in they worked fine. However when I looked at CPU-z it was showing as running at roughly 1600MHz each.
XMP setting is already on as the mobo has been overclocked professionally.
I went into bios (and I am new to this so never done this before) and I found a setting called DRAM frequency showing 1600mhz, so I changed it to 1866MHz and saved and restarted but the computer just wouldn't work then. So I reverted the changes back.
Now I know I should be able to use these at 1866MHz using XMP but i'm guessing there must be more settings to change than just that one.
Can anyone help me?
XMP setting is already on as the mobo has been overclocked professionally.
I went into bios (and I am new to this so never done this before) and I found a setting called DRAM frequency showing 1600mhz, so I changed it to 1866MHz and saved and restarted but the computer just wouldn't work then. So I reverted the changes back.
Now I know I should be able to use these at 1866MHz using XMP but i'm guessing there must be more settings to change than just that one.
Can anyone help me?