I recently got a Corsair H60 Hydro Series water cooler and installed it. But during the installation, to maintain the upright orientation of the Corsair Logo on the pump, I slightly forced the tubing a little bit when mounting the radiator on the top, and and the angle of the tubes looks worrying to me. Could anyone look at my setup and advise me on whether or not it looks safe? I wasn't sure if the pump could be orientated with the logo facing sideways or not (didn't know if standoffs would match screws, etc).
On another note, the instructions told me to mount the radiator+fan on the side, but I mounted it on the top part of my NZXT Phantom 410 instead because I didn't want to cut my cable ties on the back of the case securing my other fan cables in place.
Thanks in advance!
My Setup
On another note, the instructions told me to mount the radiator+fan on the side, but I mounted it on the top part of my NZXT Phantom 410 instead because I didn't want to cut my cable ties on the back of the case securing my other fan cables in place.
Thanks in advance!
My Setup
Facebook
Twitter
Instagram