- May 31, 2013
- 23
- 0
- 10,510
Today I installed a new water cooler on my graphics card (only on gpu, not cpu). Previously to this, the entire system worked fine. When I turn on the pc after installing water block, radiator and pump, it won't display anything on the screen. No signal.
So, thinking it was the GPU, I took it out, installed a old GPU (though the drivers are not installed), and still, I get no signal.
Then I plug the HDMI into my mobo, and use the built in Intel Graphics, and it works.
By the way, the fans on the GPU spins, so it is powered. It just doesn't display anything.
I also tried to plug the card into the Pcie below the primary one.
Are there anyone who have had a similar problem?
Any help would be much appreciated!
Specs : 980ti Zotac, mobo is msi z77a-g43, Intel 3570k, 750W PSU
So, thinking it was the GPU, I took it out, installed a old GPU (though the drivers are not installed), and still, I get no signal.
Then I plug the HDMI into my mobo, and use the built in Intel Graphics, and it works.
By the way, the fans on the GPU spins, so it is powered. It just doesn't display anything.
I also tried to plug the card into the Pcie below the primary one.
Are there anyone who have had a similar problem?
Any help would be much appreciated!
Specs : 980ti Zotac, mobo is msi z77a-g43, Intel 3570k, 750W PSU
Facebook
Twitter
Instagram