It seems everything works in my new pc build. The only thing is that when i plug in my monitor it says no signal. I have tried plugging it in to graphics card (nvidia 970) and it doesnt work. I plug it into the motherboard and still no signal. I have the 12v connection on motherboard, and i reset cmos battery, and i resettled my RAM. What should i do?
Unolocogringo
Illustrious
- Dec 31, 2007
- 7,764
- 657
- 38,390
quotemsg=17152903,0,1653]Did you plug the PCI-E power cable into the graphics card?[/quotemsg]
No however the graphics card lights are on therefore its on and there is power supplied to the card so thats not the problem, not to mention i plugged the vga cable into the motherboard as well as the graphics card
No however the graphics card lights are on therefore its on and there is power supplied to the card so thats not the problem, not to mention i plugged the vga cable into the motherboard as well as the graphics card
So i took everything out of my pc case so i could try and determine what was wrong. My hard drive spins, my PSU is supplying power, and when I disconnect the RAM my motherboard doesnt beep. I assume that means i got a defective motherboard. I will get a replacement and keep you updated!
TRENDING THREADS
-
RTX 4070 vs RX 7900 GRE faceoff: Which mainstream graphics card is better?- Started by Admin
- Replies: 59
-
Question New pc build r9 7900x3d rtx 4080 super no post only ram rgb turns on- Started by Harvey Durward
- Replies: 2
-
Question PC Shuts down during shader building on Last Of Us Part 1- Started by ohgoditschris1
- Replies: 18
-
-
Question Bought a new m.2 SSD. Will be added to my build for music programs. Do i need to delete and reinstall these programs?
- Started by rashadd26
- Replies: 10
-
Question Will this monitor be supported by my gpu or is it too much
- Started by machieb
- Replies: 4
Facebook
Twitter
Instagram