modular cables,cross-section,evga g2/p2

stroker1990

Reputable
Dec 9, 2015
23
0
4,510
Hello
I came across a table https://en.wikipedia.org/wiki/American_wire_gauge#Tables_of_AWG_wire_sizes.
I bought cables EVGA g2 / p2 where the missing second pin 3.3V. Elsewhere, mostly missing eight pins and GND. I heard that the missing eight pins GND could interfere with přetaktovanější report but again it depends on the cross section. I would like to know if purchased cables specifically http://www.alphacool.cz/produkt/CableMod_E-Series_G2_-_P2_Cable_Kit_-_BLACK-WHITE.html with missing second pin 3.3V are fine. Until now I have met with only eight missing pin, so I do not know.
 

stroker1990

Reputable
Dec 9, 2015
23
0
4,510
It became such a thing. I had to complain about the board asus x99A. Cause - after about two Dench PC shuts itself, and clicked off. It was not turned on. After complaints base of Pola iDesk q code is 00. Processor dead. I do not know what went wrong, if it was faulty cable or basic iDesk. It is enough to http://www.legitreviews.com/intel-x99-motherboard-goes-up-in-smoke-for-reasons-unknown_150008 stairs, but I did not feed corsai but EVGA.I make me crazy.