Questions about first complete computer build

Toggle sidebar Toggle sidebar
T

TheGleaner

Distinguished
Dec 8, 2015
181
0
18,680
Hello i have upgraded computers before, but now I'm completely building a new one, and have a couple questions;

I got this message on pc part picker and am wondering if its fine if i go ether way; The Corsair Dominator Platinum 32GB (4 x 8GB) DDR3-2400 Memory operating voltage of 1.65V exceeds the Intel Haswell Refresh CPU recommended maximum of 1.5V+5% (1.575V). This memory module may run at a reduced clock rate to meet the 1.5V voltage recommendation, or may require running at a voltage greater than the Intel recommended maximum. yes i plan on light to heavy overclocking.

Is a anti-static wristband necessary?

Is a anti-static mat necessary?

Thanks

 
Solution
clutchc
For trouble-free results, follow the voltage recommendation for the Haswell memory controller. Pick some RAM that is 1.5 volt. Shouldn't be hard to find, as that is the most common.

Not necessary, but wise. For a new builder, it is probably a good idea. At least until you get into the habit of safely discharging any ESD build-up before going anywhere near the motherboard.

The mat isn't necessary if the surface you build on is static-free.

I like to install the PSU first and plug it in (power off, of course). That way there is a path to earth ground for discharging static build up. Assuming you have a properly wired electrical system, of course. Also, I keeps me from dropping the PSU on the motherboard ;-)
Sort by date Sort by votes
clutchc

clutchc

Titan
Ambassador
Apr 22, 2009
43,150
411
131,790
For trouble-free results, follow the voltage recommendation for the Haswell memory controller. Pick some RAM that is 1.5 volt. Shouldn't be hard to find, as that is the most common.

Not necessary, but wise. For a new builder, it is probably a good idea. At least until you get into the habit of safely discharging any ESD build-up before going anywhere near the motherboard.

The mat isn't necessary if the surface you build on is static-free.

I like to install the PSU first and plug it in (power off, of course). That way there is a path to earth ground for discharging static build up. Assuming you have a properly wired electrical system, of course. Also, I keeps me from dropping the PSU on the motherboard ;-)
 
Upvote 0 Downvote
Solution
T

TheGleaner

Distinguished
Dec 8, 2015
181
0
18,680
no but, its the only somewhat cheap yet recommended ram i could find for the msi xpower ac, and since ive heard of problems later when you add ram thats not... well matching or in a set
 
Upvote 0 Downvote
clutchc

clutchc

Titan
Ambassador
Apr 22, 2009
43,150
411
131,790


You're not going by the recommended memory list on the motherboard site are you? That is just memory that they had time to test before releasing the board for retail. You can use any MATCHED pairs of any 1.5V DDR3 memory. What board are you using?
 
Upvote 0 Downvote
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom