Computer wont boot up after ram installation

Toggle sidebar Toggle sidebar
R

Razdel

Reputable
Dec 30, 2015
2
0
4,510
So, my new kingston hyperx fury 8gb 1866mhz arrived today and i installed it. But after turning my computer on it stays at a black screen. After that i tried putting my old ram and it works fine. Whats caisong this and how to fix this problem.

If it helps my:
motherboard - msi a55m-e33
Psu - aero cool rave 800w
Cpu - amd a8 6600k
 
Solution
Tradesman1
Might make sure you have the latest BIOS. If you do, then try pulling the DRAM, unplug and reset CMOS then try installing only the Fury, they operate off of PnP so they should simply set themselves up and go. MSI isn't the best with keeping BIOSs up to date.
Sort by date Sort by votes
R

Razdel

Reputable
Dec 30, 2015
2
0
4,510


I properly placed it till it clicked and i installed it at the same slot as my old ram

 
Upvote 0 Downvote
Tradesman1

Tradesman1

Legenda in Aeternum
Jun 5, 2013
67,883
40
126,960
Might make sure you have the latest BIOS. If you do, then try pulling the DRAM, unplug and reset CMOS then try installing only the Fury, they operate off of PnP so they should simply set themselves up and go. MSI isn't the best with keeping BIOSs up to date.
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom