- Jan 5, 2016
- 1
- 0
- 4,510
I have an odd b2 error when booting with xmp enabled. I only seem to get the error when restarting after a successful boot. If I boot from cold it starts up fine but my display intermittently cuts out. I only get this error with xmp enabled if I disable the error goes away but obviously I'd like my RAM to run at full speed. Here are the specs:
CPU: i7 6700k
MB: MSI Z170a Gaming M7
RAM: 2x8GB Corsair Vengence LPX 3000MHz (Currently in DIMM 2 and 4)
GPU: On board graphics (for now as I blew my budget on the above!!)
I've posted this in the memory forum as it only happens with xmp enabled but the manual states the following:
"Console Output/Input devices/Console initialization and
Load Option ROM (VGA, RAID, parallel ports, serial
ports……)".
This is my first build so any help that can be given would be much appreciated. Especially if I need to send components back as I only have around 20 days left before DOA expires.
Thanks,
Andy
CPU: i7 6700k
MB: MSI Z170a Gaming M7
RAM: 2x8GB Corsair Vengence LPX 3000MHz (Currently in DIMM 2 and 4)
GPU: On board graphics (for now as I blew my budget on the above!!)
I've posted this in the memory forum as it only happens with xmp enabled but the manual states the following:
"Console Output/Input devices/Console initialization and
Load Option ROM (VGA, RAID, parallel ports, serial
ports……)".
This is my first build so any help that can be given would be much appreciated. Especially if I need to send components back as I only have around 20 days left before DOA expires.
Thanks,
Andy
Facebook
Twitter
Instagram