Intel Processor Diagnostic Tool Fail

Status
Not open for further replies.

cioDuc

Reputable
Feb 2, 2016
1
0
4,510
Hi all, for some reason it looks like it doesn't even start the test, the most relevant think i see is the ..!!..ALERT..Processor under test is verified as 'SAMPLE'..!!.. What does that mean?

Here is the full log:

--- IPDT64 - Revision: 3.0.0.23.W.MP
--- IPDT64 - Start Time: 03/02/2016 00:11:33

--------------------------------------------------------------------
Processor 1
--------------------------------------------------------------------
Intel(R) spbc Module Test
Module Version: 1.0.7.64b.W
Start Time: Wed Feb 03 00:11:33 2016
Test Result - FAIL
..!!..ALERT..Processor under test is verified as 'SAMPLE'..!!..

Processor Manufacturer: GenuineIntel
Processor Brand String: Intel(R) Core(TM)2 Quad CPU Q9550 @ 2.83GHz

End Time: Wed Feb 03 00:11:33 2016
Total Time: seconds: 0
--------------------------------------------------------------------
--- IPDT64 - Temperature Monitor Results
Temperature Monitor will begin when CPULoad Test starts
Temperature Monitor Stopped

--------------------------------------------------------------------

System Information
------------------
Processor Name: Intel(R) Core(TM)2 Quad CPU Q9550 @ 2.83GHz
Processor Information: Intel64 Family 6 Model 23 Stepping 7
Number of Physical Cores: 4
Number of Logical Cores: 4
Installed System Memory: 4 GB
Operating System: Microsoft Windows 7 Professional 64-bit
Graphics Information: NVIDIA GeForce GTX 260
System Product: P5Q-PRO
System BIOS: 1306
System Serial Number: System Serial Number
--------------------------------------------------------------------

--- IPDT64 - End Time: 03/02/2016 00:11:33
--- IPDT64 - Result: Fail
 
Solution
I was running the IPDT and kept getting FAIL over and over. I did some research and found out that I had to configure the test.

This is what I did:

Run IPDT as Admin
After the first Fail, click on "tools"
Under "config", scroll down to SPBC and check "disable"
Start the test again...

worked for me

hope this helps

New_York_Giant

Reputable
Feb 4, 2016
9
0
4,520
I was running the IPDT and kept getting FAIL over and over. I did some research and found out that I had to configure the test.

This is what I did:

Run IPDT as Admin
After the first Fail, click on "tools"
Under "config", scroll down to SPBC and check "disable"
Start the test again...

worked for me

hope this helps
 
Solution
Status
Not open for further replies.