I am trying to install Windows 7 on new hard disk in my laptop HP pavilion g4 1200tx. When I started it show me unlocated first time than I format it and also make partition as per the instructions given on HP site for first time use of new hard disk and again try to install, than it stop showing the hard disk and message come up no drives were found again I try to solve it and read solution on tomshardare and it resolve but after that no device found started to come up again and again after that a new message com when I remove and put hard disk again mass storages media fail cable problem. And again finally no drives found come and it never resolve. I try a lot to solve it but no solution work. Please help me. I really need of it I waste almost 4-5 days on it. Please help me.
-
Multi-million dollar Cheyenne supercomputer auction ends with $480,085 bid — buyer walked away with 8,064 Intel Xeon Broadwell CPUs, 313TB DDR4-2400 ECC RAM, and some water leaks
I try all method but still I am not able to install Windows. Now new error start coming. Media test failure check cable, once
- Thread starter Ashish_12
- Start date
hang-the-9
Titan
- Mar 25, 2010
- 60,387
- 1,081
- 152,940
Start at the beginning, why did you replace the disk? Was the system having issues or just upgrading, if issues, what exactly? At what point exactly in the setup are you getting the driver errors and exactly what is the error message? Is it after Windows is installed and starting? Did you make sure the hard drive is seated properly?
@Hang-the-9: I'm having the same issue but it's with my HP Desktop. I replaced the hard drive because it died on me and now that I have replaced it I keep getting this message "PXE-E61: media fail, check cable". After that message appears it tell me to hit any key to continue and when I do that message just continues on popping up and wont do anything else.
I downloaded Windows 10 onto a DVD-R which I'm trying to install onto the new hard drive but it won't let me get that far to where I can do that. I'm working on it now so I hope you can help me.
I downloaded Windows 10 onto a DVD-R which I'm trying to install onto the new hard drive but it won't let me get that far to where I can do that. I'm working on it now so I hope you can help me.
hang-the-9
Titan
- Mar 25, 2010
- 60,387
- 1,081
- 152,940
That is not going to help with not being able to boot, it just won't go to the network boot when it fails to boot from the hard drive. Disabling LAN to fix the issue is like telling someone to close their eyes when they are falling from a building. Sure you won't see the issue anymore, but you'll still go splat.
TRENDING THREADS
-
-
News Firefox user loses 7,470 opened tabs saved over two years after they can’t restore browsing session- Started by Admin
- Replies: 58
-
News Apple debuts M4 processor in new iPad Pros with 38 TOPS on neural engine
- Started by Admin
- Replies: 76
-
Question Samsung SSD showing as a Western Digital with half of the storage space --any fixes?
- Started by Frostsent
- Replies: 5
Facebook
Twitter
Instagram