G.SKILL Ripjaws X Series 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 2133 (PC3 17000) Desktop Memory Model F3-2133C9D-8GXL mixed with G.SKILL Ripjaws X Series 8GB (2 x 4GB) 240-Pin DDR3 SDRAM DDR3 2133 (PC3 17000) Desktop Memory Model F3-2133C10D-8GXM DDR3 2133 (PC3 17000) Timing 9-11-11-31 Cas Latency 9 Voltage 1.6V -1.65V mixed with DDR3 2133 (PC3 17000) Timing 10-12-12-31 would this be a problem
-
T-Mobile Home Internet: Revisiting 5G connectivity for the home after two years
-
Multi-million dollar Cheyenne supercomputer auction ends with $480,085 bid — buyer walked away with 8,064 Intel Xeon Broadwell CPUs, 313TB DDR4-2400 ECC RAM, and some water leaks
DDR3 2133 (PC3 17000) Timing 9-11-11-31 Cas Latency 9 Voltage 1.6V -1.65V mixed with DDR3 2133 (PC3 17000) Timing 10-12-12-31
- Thread starter bobthorne
- Start date
Solution
voltoid27
Reputable
- Sep 17, 2014
- 609
- 0
- 5,660
Normally I'd recommend against mixing RAM, but since you have 2 kits of the same brand, I'd say it should work just fine. Keep in mind though, you'll more than likely need to run your RAM at 1.65V with DDR3-2133 10-12-12-31 timings so the slower kit can keep up. Also, be sure to position the sticks so that you have one stick from each kit in each channel. Refer to your motherboard manual for help with that.
Tradesman1
Legenda in Aeternum
- Jun 5, 2013
- 67,883
- 40
- 126,960
What CPU? Since you have them, give 'em a try. Might need additional MC voltage and depending on ZCPU may need a small OC
TRENDING THREADS
-
News Firefox user loses 7,470 opened tabs saved over two years after they can’t restore browsing session- Started by Admin
- Replies: 51
-
Question Sapphire RX 5700 XT Nitro+ is not working in main PCIe slot ?
- Started by digows
- Replies: 24
-
-
-
Question what should i look out for when buying used ryzen chips?- Started by jordanbuilds1
- Replies: 23
-
Question Upgrading GPU, do I need to worry about PCIe and lanes?
- Started by bcemail
- Replies: 5
Facebook
Twitter
Instagram