Can't find my hardisk on my PC

Karius

Commendable
Mar 24, 2016
2
0
1,510
Hello from Norway!

Firstly, thanks for a great forum, and much fine reading. This is my first post here on Tom's Hardware.

I have an ADB 5743CDX cable television decoder as standard has a WD 5000AVDS (500Mb) internal hard drive. I made an attempt to install a Samsung ST3100033AS (1TB) for see if I got bigger recording capacity. I did that. From 73 hours to about 150 hours.

The job was very simple. I installed a new unformatted disk in the decoder, and all update happening via LAN and coax cable.

I would pursue these, and installed a WD 20EZRX (2TB), and increased recording time from 73 hours to 232 hours. The same basic procedure as mentioned above. Pug and play.

So the problem: When I was going to install the WD 5000AVDS disk in my Lenovo, then can not find my PC this disc. I have tried to install it in different ones machines, but it does not come up in disk management.

Some I have spoken to suggest that the disk is defective, and this is something ADB decoder doing to prevent content from being copied.

As mentioned, whether I connect the drive to the SATA or via a USB enclosure does not appear this disc on my PC.

Is there anyone out there who has a suggestion for how I get life in this drive again? The content I'm not interested in keeping.


If I take the same hard drive and mount it in ADB decoder , so it works perfectly again . I suspect ADB to remove neo important files for booting in a conventional computer .

Thank you in advance for your attention.

Sorry for my bad English grammar. :)

Best Regards Paal
Oslo, Norway
 
Solution
Hi there Karius,

My guess would be that the drive is formatted in such a way, that the PC can recognize it even in Disk Management.
I believe it is recognized by BIOS right? It should be, as long as it is properly connected.(SATA cable + power one)

One thing you can try is to download WD's Data Lifeguard Diagnostic tool and wipe the drive with the writing zeros option. This is a data destructive process, yet you've mentioned that you don't really need the data. After that, you can check the drive's health out with both short and extended tests.

WD's DLG tool: http://products.wdc.com/support/kb.ashx?id=yLNOcN

Let me know how this goes,
D_Know_WD :)
Hi there Karius,

My guess would be that the drive is formatted in such a way, that the PC can recognize it even in Disk Management.
I believe it is recognized by BIOS right? It should be, as long as it is properly connected.(SATA cable + power one)

One thing you can try is to download WD's Data Lifeguard Diagnostic tool and wipe the drive with the writing zeros option. This is a data destructive process, yet you've mentioned that you don't really need the data. After that, you can check the drive's health out with both short and extended tests.

WD's DLG tool: http://products.wdc.com/support/kb.ashx?id=yLNOcN

Let me know how this goes,
D_Know_WD :)
 
Solution

Karius

Commendable
Mar 24, 2016
2
0
1,510
Hi D_Know_WD!

Thanks for the quick response. It is quite right that you write, I do not need the data on the disk. I will try your suggestion and I'll update you as soon as a result.

I've checked both SATA and power cable, and they are ok.

Have a nice evening!

Best regards Paal