Is my psu powerful enough ? or compatibility issues ?

G

Guest

Guest
What GPU are you using. The issue wouldn't be the mother board or CPU as Skylakes are very power efficient, Try booting with the graphics card out if you have one, if not just try getting to the bios before booting up windows. By any chance do you have any custom or after market cables because that may be an issue.

*Make sure whan you take your grpahics card out switch the display cable to the on board graphics on the motherboard back I/O
 

Harry_10

Reputable
Nov 27, 2015
75
0
4,630

I have a gtx 970 4gb
and have tried with it unplugged and no different, What could cause this error the Ram ? i still got that feeling that both ram sticks are faulty or somthing, or the cpu is faulty. Unless of course there is a compat issue
 
G

Guest

Guest


There are no compatibility issues and the power supply is fine, it could be the ram try putting them in different slots and try one at a time, also are you able to get into the bios, and are your hard rives installed properly, is your CPU brand new or second hand, I don't think it would be the CPU though
 

Harry_10

Reputable
Nov 27, 2015
75
0
4,630

Everything is brand new, i have tried changing rams round the slots everything, i can boot into the bios yes. I have tried with the hdds and ssds and without but as soon as i get to the windows logo on the boot cd it stays on it for about 15 seconds then blue screen flashes up and the system restarts. Im getting the he cpu and ram changed as i have already had the motherboard replaced and it didnt fix it so im going to try the cpu and ram but in the mean time anything else i should try ?
 
G

Guest

Guest


Its probably the ram I wouldn't think its the CPU

 
G

Guest

Guest
Maybe its the disk, if you can somehow get windows maybe booting off a flash drive will work, but i don't think anything much else can be done
 
G

Guest

Guest


Hmmm, im not sure what else to try other than swapping the ram
 

Harry_10

Reputable
Nov 27, 2015
75
0
4,630



ok :(, well ill wait for the replacement's and then see if i can get it working