Hello all.
I just purchased Kingston HyperX FURY 16GB Kit (2x8GB) 1866MHz DDR3 CL10 DIMM http://amzn.com/B00J8E8Y5C
The new RAM is causing my computer to turn off, then turn on and then turn off again every few seconds and nothing shows on my monitor.
My old sticks are G.SKILL Ripjaws Series 4GB (2 x 2GB) 240-Pin DDR3 SDRAM DDR3 1600 http://www.newegg.com/Product/Product.aspx?Item=N82E16820231277.
I have a Gigabyte GA-Z68A-D3H-B3 motherboard.
I tried putting in only one of the new sticks in at a time and still does not work. I updated my BIOS. I tried resetting CMOS. I take out the new RAM and put my old back in and the computer works fine. I apologize as I know this is a common question but all the solutions I have found does not seem to help.
Any suggestions would be appreciated. Thank you.
I just purchased Kingston HyperX FURY 16GB Kit (2x8GB) 1866MHz DDR3 CL10 DIMM http://amzn.com/B00J8E8Y5C
The new RAM is causing my computer to turn off, then turn on and then turn off again every few seconds and nothing shows on my monitor.
My old sticks are G.SKILL Ripjaws Series 4GB (2 x 2GB) 240-Pin DDR3 SDRAM DDR3 1600 http://www.newegg.com/Product/Product.aspx?Item=N82E16820231277.
I have a Gigabyte GA-Z68A-D3H-B3 motherboard.
I tried putting in only one of the new sticks in at a time and still does not work. I updated my BIOS. I tried resetting CMOS. I take out the new RAM and put my old back in and the computer works fine. I apologize as I know this is a common question but all the solutions I have found does not seem to help.
Any suggestions would be appreciated. Thank you.
Facebook
Twitter
Instagram