Hello everyone,
I know this question or similar ones have been asked many times before but
I couldn't find an answer to my specific (but generic) problem:
I have a crappy computer from medion (Medion Akoya P5203 DR) with the
mainboard MS-7797G (msi?).
The installed ram was 2x2gb ddr3-1600 which ran 1600.
I have now exchanged them with 2x4gb ddr3-1600.
However the new ones run only at 1333 instead of, preferably, the 1600.
Note that the old modules run at 1600 even after I put them in again.
I've uploaded a few screenshots from cpu-z here:
http://imgur.com/a/DugzN
Things I gathered and tried:
1333 appears to be the default frequency. But why do the old modules run properly?
Changing XMP profile: I havn't found any such settings in this mainboards bios.
Change memory frequency in bios: It's greyed out and so far haven't found a way to
enable/change it. I found the shortcut Ctrl+F1 to apparently enable all settings in a
thread somewhere here, but it didn't do anything, where ever I tried it.
BIOS update: Whatever this may help: There appears to be no update available for
this mainboard.
What else can I try out?
Any more information you guys need to please help me?
Thanks in advance and
kind regards
Stefan
I know this question or similar ones have been asked many times before but
I couldn't find an answer to my specific (but generic) problem:
I have a crappy computer from medion (Medion Akoya P5203 DR) with the
mainboard MS-7797G (msi?).
The installed ram was 2x2gb ddr3-1600 which ran 1600.
I have now exchanged them with 2x4gb ddr3-1600.
However the new ones run only at 1333 instead of, preferably, the 1600.
Note that the old modules run at 1600 even after I put them in again.
I've uploaded a few screenshots from cpu-z here:
http://imgur.com/a/DugzN
Things I gathered and tried:
1333 appears to be the default frequency. But why do the old modules run properly?
Changing XMP profile: I havn't found any such settings in this mainboards bios.
Change memory frequency in bios: It's greyed out and so far haven't found a way to
enable/change it. I found the shortcut Ctrl+F1 to apparently enable all settings in a
thread somewhere here, but it didn't do anything, where ever I tried it.
BIOS update: Whatever this may help: There appears to be no update available for
this mainboard.
What else can I try out?
Any more information you guys need to please help me?
Thanks in advance and
kind regards
Stefan