"No Signal" after removing Graphic card and trying to use on board GPU

[sonuyos_rox]

Need help.

So I just removed my card I.e. R7950 from my PC, as I just sold it.

It was connected to DVI,

Now that my mobo I.e. Maximus Ranger 8, has no DVi but into HDMI,

When I connect and start, the PC boot but doesn't send signal to the Monitor.

I have reseted CMOS by pressing the CLR_CMOS BUTTON and even removed the battery for few mins (System was full off when I did) and tried to boot,

Still doesn't work.

However when I put the PC in LN2 mode, it gives display but again in LN2 mode, HDD does not work, probably because that mode is for Liquid Nitrogen., Sub zero temp.

So what should I do? How to get it working?

Am kinda lost...

 

[sonuyos_rox]

Never mind, fixed it by going into bios using spare card and then changing gfx to IGFX from auto, and then it worked.