I do not know what plug this is that is installed with my case. Need help to find out what it is and what it connects to.

Toggle sidebar Toggle sidebar
C

ChuckyPC

Reputable
Jun 30, 2015
36
0
4,530
http://imgur.com/a/JZZV1
^^^
shows what the plug is.

I think it is a molex cable (which someone else told me), and I was wondering how important it is because it was installed with my case. It is broken, and I do not know whether i need to send my case in to get a refund. Do I need it, or can I deal without it?

My case: CM Storm Stryker Full Tower
 
Solution
nukemaster
You are right about the cable(molex LP4 type). You will be best to flow it to see what they used it for. I would guess a fan controller(fans tend to run on 12 volts), but you also have a hot swap bay(should only need 5 volts).

You can get a new pin or solder that one if you have the equipment. The pin is held in with little fingers. You may be able to contact Coolermaster to have just a new cable sent out if it has a plug in the other end attached to the case. I have done this for an Antec case with a broken usb port(better than sending the case away).
Sort by date Sort by votes
nukemaster

nukemaster

Titan
Nov 23, 2004
19,626
6
74,965
You are right about the cable(molex LP4 type). You will be best to flow it to see what they used it for. I would guess a fan controller(fans tend to run on 12 volts), but you also have a hot swap bay(should only need 5 volts).

You can get a new pin or solder that one if you have the equipment. The pin is held in with little fingers. You may be able to contact Coolermaster to have just a new cable sent out if it has a plug in the other end attached to the case. I have done this for an Antec case with a broken usb port(better than sending the case away).
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom