Hi i recently created a new PC build and was planing on running a Fan based airflow GPU in my case but due to lack of availability i opted for an MSI Geforce 1080 Sea Hawk X witch has an closed loop 120mm Radiator.
Because i run a midi-tower im a bit torn between where to place the radiator and i am looking for suggestions to where to put it and what configuration to use.
My fan setup:
Im using a Phanteks Enthoo EVOLV ATX case and have a Corsair hydro 110i using a push pull config in to the case i then have 2 120 mm Corsair air flow quiet fans blowing air out of the case in the top of the case and a identical 120 mm fan blowing air out of the exhaust fan slot in the back of the case.
My question is would you recommend me using one of the top/roof slots in the case so the exhaust port can remain obstruction free or should i use t exhaust fan and rely on the top fans to exhaust all hot air ? Also should i run a push, pull or push and pull config on the MSI 120 mm radiator ?
I hope i was able to explain properly and apologize in advance for poor grammar.
Because i run a midi-tower im a bit torn between where to place the radiator and i am looking for suggestions to where to put it and what configuration to use.
My fan setup:
Im using a Phanteks Enthoo EVOLV ATX case and have a Corsair hydro 110i using a push pull config in to the case i then have 2 120 mm Corsair air flow quiet fans blowing air out of the case in the top of the case and a identical 120 mm fan blowing air out of the exhaust fan slot in the back of the case.
My question is would you recommend me using one of the top/roof slots in the case so the exhaust port can remain obstruction free or should i use t exhaust fan and rely on the top fans to exhaust all hot air ? Also should i run a push, pull or push and pull config on the MSI 120 mm radiator ?
I hope i was able to explain properly and apologize in advance for poor grammar.