- May 30, 2016
- 175
- 0
- 1,680
What can I enable / disable for best performance from these network adapters
- Thread starter killastrra
- Start date
Solution
Karel_1_BE
Commendable
- Jul 19, 2016
- 17
- 0
- 1,510
IT depends of what you're using to connect with other devices.
The "bluetooth" one is for connecting with another device by bluetooth like your smartphone, earphones, ...
The "qualcomm..." is for having WiFi, connecting to the internet by using Wireless signals
The last one "realtek..." is used for ethernet cable. If you don't want to use WiFi to connect with the internet, but by an ethernet cable, then you need that.
Actually, the OS is capable to switch between those channels. My gaming pc uses ethernet, but the drivers for WiFi is enabled. It is just turned off by the configurations. While my laptop has both drivers, but mainly uses the WiFi. I sometimes plug in an ethernet cable if i need to download a large file.
The "bluetooth" one is for connecting with another device by bluetooth like your smartphone, earphones, ...
The "qualcomm..." is for having WiFi, connecting to the internet by using Wireless signals
The last one "realtek..." is used for ethernet cable. If you don't want to use WiFi to connect with the internet, but by an ethernet cable, then you need that.
Actually, the OS is capable to switch between those channels. My gaming pc uses ethernet, but the drivers for WiFi is enabled. It is just turned off by the configurations. While my laptop has both drivers, but mainly uses the WiFi. I sometimes plug in an ethernet cable if i need to download a large file.
das_stig
Glorious
- Jul 24, 2009
- 8,278
- 29
- 46,040
I have the same NIC and find the defaults plus the following give best performance ..
Flow Control = Rx / Tx Enabled.
IPv4 Checsum Offload = Rx / Tx Enabled.
Jumbo Frames : 9KB MTU - but only if router supports it.
Speed & Duplex : xxx Full Duplex - match this to your connection, auto should always give you fastest, but can incorrectly detect depending on CAT cable.
Flow Control = Rx / Tx Enabled.
IPv4 Checsum Offload = Rx / Tx Enabled.
Jumbo Frames : 9KB MTU - but only if router supports it.
Speed & Duplex : xxx Full Duplex - match this to your connection, auto should always give you fastest, but can incorrectly detect depending on CAT cable.
TRENDING THREADS
-
-
Question Microphone buzzing stops when pc case is touched- Started by ognjenzzz
- Replies: 2
-
-
Discussion Can graphics cards with external PCIE power connectors run off of just the power from the PCIE slot?- Started by Order 66
- Replies: 15
-
Question Is recommended format a new ssd (about security) before install windows?
- Started by Tams_Hardware
- Replies: 2
-
-
Facebook
Twitter
Instagram