Need help installing fans!

Danell_1

Commendable
Oct 19, 2016
5
0
1,510
Hello so I have 2 fans in this photo (http://imgur.com/zext9uh) and want to know which orientation or which way air is going. I also have one in the rear (http://imgur.com/CmMwbey) same question as in which way air is going. I just installed my hyper 212 evo and wondering if it was right? (http://imgur.com/ZoduZSl) and was planning on installing 1 120mm here (http://imgur.com/rjM6sQK), and also maybe 2 120mm here if needed (http://imgur.com/BgAL6DL). What I plan is having the two top as exhaust and rear also exhaust and then front intake and then the 2 120mm also intake. I'm new to pc building so any help is appreciated.
(Edit: all fans connected to fan controller)
 
Solution
1) Those are setup as an exhaust fan.
2) That's not the rear, that's the front. It is setup as intake.
3) I personally prefer to point it towards the rear not the top, to get the fan pulling a little air over the memory, but it's not a big deal.
4) Good idea. Did someone cut that hole with a can opener?
5) Ehhhhh, side fans have never been a big hit for me. It's probably not too bad since they are so low on the side they won't screw up airflow too much.
1) Those are setup as an exhaust fan.
2) That's not the rear, that's the front. It is setup as intake.
3) I personally prefer to point it towards the rear not the top, to get the fan pulling a little air over the memory, but it's not a big deal.
4) Good idea. Did someone cut that hole with a can opener?
5) Ehhhhh, side fans have never been a big hit for me. It's probably not too bad since they are so low on the side they won't screw up airflow too much.
 
Solution

Danell_1

Commendable
Oct 19, 2016
5
0
1,510
Thanks timeconsumer! So it will just be fine if the front intake and rear intake? And then just the top 2 exhaust. I just want to make sure my CPU cooler is pushing air towards the outake on top?
 

Danell_1

Commendable
Oct 19, 2016
5
0
1,510
didn't read your #4 right, when installing the CPU fan the ram was big that it wouldn't fit so I moved them to 2 & 4, how do I make my heat sink the other way? Couldn't find out how to turn it.
 
It depends on your motherboard and the installation brackets for the cooler. Check the manual. But again, it isn't a very big deal to have it pointed up instead. And yes, you'll be okay with 1 intake and 3 exhaust. If the intake airflow isn't sufficient you will notice with poor GPU temps, in which case putting 1 or maybe 2 more intake in one of those lower side panel holes should work well.