two story house, dsl router is upstairs. needing to get internet downstairs. entire house is wired with cat5 cables using old phone jacks, i get that i have to wire rj45 ends to replace the phone jack ones. but when it comes to wiring the NID im so lost. opened up the NID box and it has two wires from street to NID ( blu and blu/whte and from there it has two wires (same colors) going into the house (my master room phone jack to dsl router)...how would i be able to make this happen if at all possible. the NID box is the newer ones that have a closed lid where both blu and blu/whte wires meet inside it. wireless router wouldnt be an option since materials used to build the house kills the wifi signal throughout the house.
-
T-Mobile Home Internet: Revisiting 5G connectivity for the home after two years
-
Multi-million dollar Cheyenne supercomputer auction ends with $480,085 bid — buyer walked away with 8,064 Intel Xeon Broadwell CPUs, 313TB DDR4-2400 ECC RAM, and some water leaks
dsl how to
- Thread starter warsmokey
- Start date
Solution
jsmithepa
Polypheme
- Jun 14, 2014
- 13,096
- 263
- 60,840
Wow-wow-wow. Before we even go further on this, are you sure you have a full CAT5 going into each jack and, with all 4 pairs of wires? and you see a bundle of CAT5 at the "closet" with the number of CAT5 equal to jacks available?
so let me understand, the house has Cat5 cabling going from room to room and was configure to run a phone system using only 2 pairs on a standard phone jack plug. and now you want to change it to use it to rj45 plugs and utilize it for your router. ?
only issues I see is, the other end of the wires are connected where ? and how many drops of CAT5 are you looking at (could not see your picture)
a direct answer to your question is how do I wire Rj45 Connector to Cat5 cabling is where you will see how to set your wires in the connector
TRENDING THREADS
-
News Apple debuts M4 processor in new iPad Pros with 38 TOPS on neural engine- Started by Admin
- Replies: 53
-
News Firefox user loses 7,470 opened tabs saved over two years after they can’t restore browsing session
- Started by Admin
- Replies: 54
-
-
Question Sapphire RX 5700 XT Nitro+ is not working in main PCIe slot ?
- Started by digows
- Replies: 24
-
Question I replaced my broken Mother Board and now my windows wont start- Started by Crystal_B
- Replies: 16
-
Facebook
Twitter
Instagram