Newly built PC crashes

TiteBugit

Commendable
Oct 23, 2016
10
0
1,510
Everytime I turn on my NEWLY built PC, it crashes. I mean it boots, and I can halfway install Windows, but then it just crashes. Boom. No signal to my display no more. And then for some odd reason, I'm only able to boot it up after like an hour. If I attempt to turn it on before that time, the fans spin, but no signal comes to my screen. Weird. I've troubleshooted it a couple of times. I've reseated the cpu, the heatsink, the Gpu, I've replaced sata cables, replugged power cables, switched ram slots, a lot of things. Nothing seems to work. My list of parts consists of an X4 860k, an AsRock FM2A68m motherboard, a Western Digital 320gb hard drive, a gigabyte RX 460 2gb, an EVGA 430w psu, a Xion PC case, 8gb of DDR3 Avexir ram. Basically, my PC turns on, right. It boots to the bios, good. But then, out of NOWHERE, my PC freezes, I shut it off, and then when I attempt to turn it on again the fans spin, but there's still no signal to my screen. Then I have to wait a while and eventually I'm able to turn it on AGAIN. It's a cycle. And I want it to stop. So, thank you :)
 

TiteBugit

Commendable
Oct 23, 2016
10
0
1,510


Yup I've fully powered the motherboard. I plugged in the 20+4 pin connector, and the 4pin CPU connector. When I installed and reinstalled the CPU, I made sure to check if any of the pins were bent, they weren't.
 

TiteBugit

Commendable
Oct 23, 2016
10
0
1,510


Will try that. Maybe it'll work... I'll keep updated with my progress. Thanks
 

TiteBugit

Commendable
Oct 23, 2016
10
0
1,510


I only have one stick of ram but that is a problem I was considering during troubleshooting.