hi..i hope someone can help me or advise me on this. im tempted to just call my retailer at this point and get them to install it for me. but was hopeing somone els that has this card can advise me on how to do this. my problem is mounting the fan to the rad..i can not do it. only 2 of them seem to bite to the rad..but the other 2 seem to be imposible..iv tryd for hours with no luck and im fed up. is my unit bust or somthing.. i swear it should not be this hard to mount a fan to a rad.
inno 3d 1080 ichill hybrid black..problem installing.
- Thread starter domjam
- Start date
Solution
mcnumpty23
Polypheme
- Jul 15, 2011
- 15,519
- 0
- 66,960
never used one of those hybrid cards
but mounted plenty fans to rads so no it shouldnt be difficult
unless theres something wrong with
1--the screws
2--the holes for the screws on the rad
technically its possible to only use 2 screws if its diagonally opposite corners
but 4 screws is obviously better but i have mounted fans with only 2 screws before on opposite corners
but mounted plenty fans to rads so no it shouldnt be difficult
unless theres something wrong with
1--the screws
2--the holes for the screws on the rad
technically its possible to only use 2 screws if its diagonally opposite corners
but 4 screws is obviously better but i have mounted fans with only 2 screws before on opposite corners
mcnumpty23
Polypheme
- Jul 15, 2011
- 15,519
- 0
- 66,960
test the screws in the holes with out the fan--dont need to screw all the way down though as no idea if theres anything
below the holes that could get punctured by screwing in too far
do they screw in then?
if not something wrong with the holes
either the thread or too small/big
below the holes that could get punctured by screwing in too far
do they screw in then?
if not something wrong with the holes
either the thread or too small/big
TRENDING THREADS
-
-
RTX 4070 vs RX 7900 GRE faceoff: Which mainstream graphics card is better?- Started by Admin
- Replies: 9
-
-
-
-
Facebook
Twitter
Instagram