- Mar 21, 2015
- 181
- 8
- 18,695
Hello, as everyone knows from my previous thread I have just recently upgraded from an AMD build to an Intel build. Now I am going to be using the exact same case from the AMD build, which was then cooler Master haf X case. I will also be reusing a 360 mm" radiator as well. However, I do have a question and that is what is the size without rubber grommets of the inlets and outlets on the back of the haf X case?
The parts that I have ordered alphacool single bay reservoir without pump alphacool eisbaer pump and reservoir combo (already owned and installed) 360 mm: koolance radiator (already owned and installed) rigid compression fittings by Primo chill 3/8 Inner diameter and 1/2 outer diameter. Primo chill 1/2 outer diameter Petg hard-line Tubing. 140 mm koolace radiator EK water block for PNY 1080 GTX XLR8 EK backplate for GPU bits power pass-through for drain 90° elbow for drain and Barb for drain (already owned) PVC tubing for drain and Tee for drain
Now with me bending the pipes and doing all this work, I would like to install the field line that runs directly to the pump/reservoir CPU block combo, so that way I don't have to try the case on its side to fill it up. And in order for me to achieve this I want to route the pipe up to the default inlets and outlets of the case that are located on the back of the case. Now if I was to do this I would basically need some kind and nipple and or maybe both in marital and female connection at the inlet or outlet position to secure everything. So that leads me to restating my question, what size without the rubber grommets are the three predefined holes let cooler Master included for water cooling located on the back of the haf X case. Also, I need to know what size fittings I would need to achieve this.
The parts that I have ordered alphacool single bay reservoir without pump alphacool eisbaer pump and reservoir combo (already owned and installed) 360 mm: koolance radiator (already owned and installed) rigid compression fittings by Primo chill 3/8 Inner diameter and 1/2 outer diameter. Primo chill 1/2 outer diameter Petg hard-line Tubing. 140 mm koolace radiator EK water block for PNY 1080 GTX XLR8 EK backplate for GPU bits power pass-through for drain 90° elbow for drain and Barb for drain (already owned) PVC tubing for drain and Tee for drain
Now with me bending the pipes and doing all this work, I would like to install the field line that runs directly to the pump/reservoir CPU block combo, so that way I don't have to try the case on its side to fill it up. And in order for me to achieve this I want to route the pipe up to the default inlets and outlets of the case that are located on the back of the case. Now if I was to do this I would basically need some kind and nipple and or maybe both in marital and female connection at the inlet or outlet position to secure everything. So that leads me to restating my question, what size without the rubber grommets are the three predefined holes let cooler Master included for water cooling located on the back of the haf X case. Also, I need to know what size fittings I would need to achieve this.
Facebook
Twitter
Instagram