- Dec 26, 2014
- 11
- 0
- 4,510
I'm currently sleeving the cables on my semi modular EVGA Supernova 750B2. To avoid having to use pinnout diagrams I've been removing and sleeving each wire one by one, which has so far worked fine. However, after sleeving and putting combs on an 8 to 6+2 pin modular PCI-E cable (labeled VGA for some reason) I've noticed the pins on the connectors don't match up. For example, a wire has one pin in the corner of the 8 connector, and the other in the middle of the 6+2. Is this normal? Also, if not, where can I find a diagram showing which wire goes where?
Facebook
Twitter
Instagram