I have a really terrible pc Intel Atom 330 processor and integrated graphics, I decided to upgrade so I bought the r-H81M motherboard, intel pentium g3250 processor and AMD Radeon R5 230, I know that's not very strong pc but will serve for mc,now problem is that i do not know what to do after installing the hardware. on youtube and find bunch of hardware video but do not know what to do after i first turn on the pc
change the motherboard, CPU and graphics card
- Thread starter Dejan_3
- Start date
Solution
assuming everything is wires correctly.... boot it, and go to Bios, and look as per manual :
to see your Hard drive(s) are showing, your ram is all recognized etc. etc., then press F10 Save and exit, it will reboot into your OS
At this point it will depend on the OS you have;
Windows 7 will just chug along for a few minutes to recognized the new hardware once its done I suggest looking into device manager and see what drivers need to be updated (yellow or red triangle)
Windows 10 will react in a number of ways.. 1. if you have MS account login, it will or Should do the same as windows 7 above 2. no MS account, it may want to be re-initialized with serial number.
to see your Hard drive(s) are showing, your ram is all recognized etc. etc., then press F10 Save and exit, it will reboot into your OS
At this point it will depend on the OS you have;
Windows 7 will just chug along for a few minutes to recognized the new hardware once its done I suggest looking into device manager and see what drivers need to be updated (yellow or red triangle)
Windows 10 will react in a number of ways.. 1. if you have MS account login, it will or Should do the same as windows 7 above 2. no MS account, it may want to be re-initialized with serial number.
not likely no, but expect windows to not have the hardware drivers (keep new motherboard cd on hand) and expect the drivers on cd to not be windows 7 compatible as well.. but you can get them on the web site
https://www.asus.com/supportonly/H81M-R/HelpDesk_Download/
I just did it, and now everything was normal I went into the bios I have not changed anything when I reset, i must choice of whether to start windows normally or repair windows, when i choose to run normally only be reset, when you choose a windows repair only say after 10 minutes can not be the solution and turn off the pc, how to figure this out?
boot into bios, when yougo to SATA Settings ;
1. do you see your hard drive and proper size
2. is SATA for that drives IDE or AHCI?
1. do you see your hard drive and proper size
2. is SATA for that drives IDE or AHCI?
TRENDING THREADS
-
Question should i put the new 3050 lp in a sff hp g3?- Started by jordanbuilds1
- Replies: 14
-
-
-
-
-
Facebook
Twitter
Instagram