Ethernet wire as speaker wire

Status
Not open for further replies.

Jonfess

Commendable
Mar 24, 2016
43
0
1,540
I have two 260 watt 8ohm speakers, two 150 watt 8ohm speakers on top so that's already 4 wires (8 individual) then I have two smaller speakers for higher sounds which is 6wires (12 individual)

What I was wondering was can I hook all this up with two Ethernet cables so I don't have 6 speaker wires and a RCA cable, I'll just have 2 speaker wires and my RCA cable

Right now that's all I have it may take awhile for me to get proper speaker wire if I could
 

mrmez

Splendid
Interference-wise it should be fine. Digital data would be far more sensitive than analogue audio.

Distance is also a critical factor, but I probably wouldn't go for anything smaller (higher gauge number) than 18.

Ethernet wasn't initially designed to carry power. PoE applications can transmit ~25w as standard, some new stuff up to ~60w, but I don't know how many wires they are using, I'd assume multiple pairs since the initial spec was 15w.
Either way, it's miles off 260w.
 
No this wont really work very well.

Ethernet is 24awg solid wire, for your 260w power level you should be at minimum using 16awg strandard.
Stranded wire allows more current then solid so this would be more like 24gauge solid vs 12 gauge solid.

I also couldnt image the twisted pair helping interfernece wise
 
If all you have is ethernet cable you might be able to get away using it but not one run for all the speakers. Using one ethernet cable for each pair or better yet each speaker would probably be OK. You have to be careful to use the same wires at each end. If you make a mistake and it shorts your amp it could damage it severely.
 

Jonfess

Commendable
Mar 24, 2016
43
0
1,540
I am using a stand for my TV and with all my equipment in there I had no room for my Xboxes or my dish reciever so I was moving it to one of my cabnents ment for the stuff but my room is set up horribly so there is a closet that I need access to so I can't set it next to my speakers but I also don't want 7 wires running right where I can see them also the wire is a little heavier then normal Ethernet wire
 
Status
Not open for further replies.