So i just removed my s340 elite's front panel to change the fan setup on my AIO.
In the process i snapped two of the top pegs off. So the top half of the panel slides in no problem but it isn't a super firm fit and doesn't snap in like the bottom which still has pegs. I think what i did was pull on the bottom and not the top, which applied too much pressure and angle to the top pegs which snapped them. Should i try and pull the top and bottom off at the same time next time?
In the process i snapped two of the top pegs off. So the top half of the panel slides in no problem but it isn't a super firm fit and doesn't snap in like the bottom which still has pegs. I think what i did was pull on the bottom and not the top, which applied too much pressure and angle to the top pegs which snapped them. Should i try and pull the top and bottom off at the same time next time?