Are there any hard disk drives that have the spinning hard disk platter(s) toward the bottom of the drive, and the electronic controller board (PCB) located above the platters?
If not, why not?
Does the answer to this question depend mainly on...
- minimizing heat generation
- minimizing vibration or mechanical resonance
- ease of assembly, and thus cost of manufacturing
- minimizing the thickness/volume of the hdd
...or some other factor?
If not, why not?
Does the answer to this question depend mainly on...
- minimizing heat generation
- minimizing vibration or mechanical resonance
- ease of assembly, and thus cost of manufacturing
- minimizing the thickness/volume of the hdd
...or some other factor?
Facebook
Twitter
Instagram