- Apr 18, 2017
- 2
- 0
- 510
Hey there,
so about a year ago I upgraded my system to the 970 Pro Gaming/Aura motherboard, along with my AMD FX-8350 CPU (Bringing my Evo 212 over from my old system) to get some more power in my gaming. That was successful, but a few short months later I started getting blue-screens anytime my system was put under intense use.
As it stands right now, I can use my computer for about two weeks before it starts blue-screening again, I open the system up clean what dust I can find and replace the thermal paste, which is usually still wet. This nets me usually about a 5C degree heat loss, which will last for another two or so weeks before the cycle starts again.
Idling, my heats jump around usually in the mid-twenties, the 22-30C range. Under load my heats tend to sit around the mid-forties, 40-49C range, though it will spike and hit the 50C range occasionally.
In terms of airflow, the system theoretically should be heaven, half a dozen fans as part of the case itself with little in terms of cording in the way, the Evo 212 is set to pull configuration blowing at a rear fan which then blows the air out of the computer, with fresh air being blown in from the front.
(Not the best picture, but gets the point across)
I was wondering if any if you fine folks had any suggestions, I've wrestled with this problem for at least six months, trying different thermal pastes and paste laying techniques, I've considered getting a second fan on the Evo 212 to add a push configuration and even thought about replacing it altogether, as one of the edges has gotten slightly bent.
Thanks for any help you can offer.
so about a year ago I upgraded my system to the 970 Pro Gaming/Aura motherboard, along with my AMD FX-8350 CPU (Bringing my Evo 212 over from my old system) to get some more power in my gaming. That was successful, but a few short months later I started getting blue-screens anytime my system was put under intense use.
As it stands right now, I can use my computer for about two weeks before it starts blue-screening again, I open the system up clean what dust I can find and replace the thermal paste, which is usually still wet. This nets me usually about a 5C degree heat loss, which will last for another two or so weeks before the cycle starts again.
Idling, my heats jump around usually in the mid-twenties, the 22-30C range. Under load my heats tend to sit around the mid-forties, 40-49C range, though it will spike and hit the 50C range occasionally.
In terms of airflow, the system theoretically should be heaven, half a dozen fans as part of the case itself with little in terms of cording in the way, the Evo 212 is set to pull configuration blowing at a rear fan which then blows the air out of the computer, with fresh air being blown in from the front.
I was wondering if any if you fine folks had any suggestions, I've wrestled with this problem for at least six months, trying different thermal pastes and paste laying techniques, I've considered getting a second fan on the Evo 212 to add a push configuration and even thought about replacing it altogether, as one of the edges has gotten slightly bent.
Thanks for any help you can offer.
Facebook
Twitter
Instagram