Using a Hard disk which have been fixed with a DIY

Ruwaisasin

Prominent
May 1, 2017
1
0
510
So my pc was set up under a desk which i put my keyboard, mouse and monitor on. one day, by mistake the pc fell on its side, however not hard as i have a carpet floor instead of tiles or other hard materials.

Then the problem started, my screen all of a sudden froze and simply wont respond, such as clicking the start button will open the menu but it won't respond again afterward (thus its pretty much will stay open without me being able to click it). when i tried to reboot it up after tightening all kind of cables which might have gone loose, i boot it up and it worked, however far slower than the normal speed my pc usually boot, black screen before showing the log in screen (the cursor does work). and then the freezing screen happened again. next when i rebooted it, i can hear the sound of a disk spinning, and stopping, spinning again, and stopping again like its trying to load the data but failed. meanwhile on the screen the pc simply state "A disk read error has occurred, ctrl+alt+del to restart". so i conclude this might be a faulty hard drive thus i decided to take the hard drive off.

I cleaned it from dust and attempted to shake it as gently as possible, so maybe i can hear if there is any part that's damaged (not sure if this is the way tho). then i put it on a flat surface, connected the cable, and rebooted my pc. the pc boot up nicely, like how it normally does, the failing disk sound i described before has disappeared , in fact the drive made nearly no noise at all, so i suppose the problem was solved.

however i am worried even though it worked (right now i'm typing this from my pc and still the problem did not return) it might simply be a momentary fix because of me gently shaking it. so my question:

should i keep using it? so far there's absolutely no problem and it make no weird noises

will using it damaged it even further and thus i can't recover the data? should i buy a new one and transfer the data in the disk?

how do i transfer the data in the disk? (which included the OS).

Thanks
 

USAFRet

Titan
Moderator


To transfer all the data do a new drive, like this:
-----------------------------
Verify the actual used space on the current drive is significantly below the size of the new SSD
Download and install Macrium Reflect (or Samsung Data Migration, if a Samsung SSD)
Power off
Disconnect ALL drives except the current C and the new drive
Power up
Run the Macrium Reflect (or Samsung Data Migration)
Select ALL the partitions on the existing C drive
Click the 'Clone' button
Wait until it is done
When it finishes, power off
Disconnect ALL drives except for the new drive
Swap the SATA cables around so that the new drive is connected to the same SATA port as the old drive
Power up, and verify the BIOS boot order
If good, continue the power up

It should boot from the new drive, just like the old drive.
Maybe reboot a time or two, just to make sure.

If it works, and it should, all is good.

Later, reconnect the old drive and wipe as necessary.
Delete the original boot partitions, here:
https://social.technet.microsoft.com/Forums/windows/en-US/4f1b84ac-b193-40e3-943a-f45d52e23685/cant-delete-extra-healthy-recovery-partitions-and-healthy-efi-system-partition?forum=w8itproinstall
-----------------------------
 

TRENDING THREADS