Reassembling my PC components Into a new case I decided on buying the Enthoo Pro by Phanteks as I liked the design, all has gone smoothly up until this point of the two fans that shipped with this case are not running, they're plugged Into the hub already and the SATA 12v Power Input cable Is also connected to a SATA power connector. The case also comes with a 4 pin fan connector that goes from hub to the CPU FAN slot on the motherboard as the manual states, however this lead does not reach and now I'm at a dilemna. The manual also says you can use other slots such as: CPU_Fan2, CHA_Fan and OPT_Fan. I however don't see any of those slots on my motherboard.
Pictures: http://imgur.com/a/9Eatm
Manual: http://www.phanteks.com/assets/manuals/PH-PWHUB.pdf
Pictures: http://imgur.com/a/9Eatm
Manual: http://www.phanteks.com/assets/manuals/PH-PWHUB.pdf