- Jan 29, 2015
- 22
- 0
- 18,510
Good evening,
I installed my HP Z620 WS with Dual cpu E5-2690.
My temps on rendering a still image are as of the image:
In fact they were 77 with 74 measured on HP Performance.
I installed my HP Z620 WS with Dual cpu E5-2690.
My temps on rendering a still image are as of the image:
In fact they were 77 with 74 measured on HP Performance.
Are these temps high ?
A noise coming from the CPU, but it is annoying only when 'High performance ' power plan ENABLED. If I chose the Power saving mode, then the scratchy noise disappears .
When testing in Passmark, the 2D MARK makes this sound synced to each action in the test.
When testing in Passmark, the Disk sequential read/write - this sound goes continuously .
Thank you
Facebook
Twitter
Instagram