4 Pin Y-Splitter Adapter Cable

Toggle sidebar Toggle sidebar
Specter141

Specter141

Commendable
Nov 28, 2016
7
0
1,510
I have an MSI B150m Night Elf and x4 Corsair Air Series Quiet Edition High Airflow Red Led Fans. My mobo had 3 fan connectors... 1 for the CPU Fan (CPUFan1), 4 Pin PWM (Sysfan1) and a 3 Pin (Sysfan2). Can I use two of this Adapter Cable on the 4 Pin PWM and 3 Pin connector on my mobo? Unfortunately... there aren't any available Fan Hubs here in my place so I wanna try this cable if it will work fine.

http://www.lazada.com.ph/4pin-pwm-to-34-dual-pwm-computer-case-fan-power-sleeved-adaptercable-5134034.html?ff=1
 
Solution
dudmont
sure, just make sure the fans aren't combining to run more than the amps that connector can put out.
I run multiple splitters(noctuas and silverstones), very few computer fans run the amperage that's going to create problems(think beastly Delta fans). Run like fans on each splitter, set up the fan curve in the Bios and you'll be sitting cool. Your system and all monitoring software will only recognize the one fan that's attached to the 4 pin, but like fans will run at the same rate, so no sweat.
Sort by date Sort by votes
dudmont

dudmont

Reputable
Feb 23, 2015
1,404
0
5,660
sure, just make sure the fans aren't combining to run more than the amps that connector can put out.
I run multiple splitters(noctuas and silverstones), very few computer fans run the amperage that's going to create problems(think beastly Delta fans). Run like fans on each splitter, set up the fan curve in the Bios and you'll be sitting cool. Your system and all monitoring software will only recognize the one fan that's attached to the 4 pin, but like fans will run at the same rate, so no sweat.
 
Upvote 0 Downvote
Solution
You must log in or register to reply here.

TRENDING THREADS

Latest posts

Moderators online

Share this page

COMPANY
RESOURCES
FOLLOW
Top Bottom