- Jun 18, 2017
- 3
- 0
- 510
Hello, (Unsure whether to put this in Memory, Components, or "Overclocking")
I'm having some issues with getting my newly built computer fully set up.
Pertinent Specs:
CPU: Ryzen 5 1600x
Memory: Ripjaws V Series 16GB DDR4 3200MHz
MoBo: Gigabyte AB350 Gaming 3 (rev. 1)
The computer boots fine normally, I've installed all the drivers onto a fresh Windows 10 set and managed to run games. I then decided to set the RAM's clockspeed up to its rated 3200MHz from 2400MHz, and restarted. Computer then will repeatedly attempt to boot but shuts down after ~ 3 seconds. Timings and voltage are at the base rates given by G.Skill.
Any ideas on how to fix this other than reverting to old speeds?
I'm having some issues with getting my newly built computer fully set up.
Pertinent Specs:
CPU: Ryzen 5 1600x
Memory: Ripjaws V Series 16GB DDR4 3200MHz
MoBo: Gigabyte AB350 Gaming 3 (rev. 1)
The computer boots fine normally, I've installed all the drivers onto a fresh Windows 10 set and managed to run games. I then decided to set the RAM's clockspeed up to its rated 3200MHz from 2400MHz, and restarted. Computer then will repeatedly attempt to boot but shuts down after ~ 3 seconds. Timings and voltage are at the base rates given by G.Skill.
Any ideas on how to fix this other than reverting to old speeds?
Facebook
Twitter
Instagram