So the rad uses two 120mm fans and is being used for intake in a NZXT S340 case.
I think the case is needing a bit more intake air. Feels a little starved for air.
I was thinking about replacing either the bottom or the top 120mm fan for a 140mm (can only do that with one of them, because the other would be holding the AIO in place, so probably the bottom fan).
The case has either two 120mm or two 140mm mounting holes in the front.
So, bottom line, this 140mm fan would be cooling the rad, in part, and giving extra out cooling for the case (on the part of the fan that goes out of the rad).
Would I lose a lot of performance on the AIO, with this setup? Not worth it?
I think the case is needing a bit more intake air. Feels a little starved for air.
I was thinking about replacing either the bottom or the top 120mm fan for a 140mm (can only do that with one of them, because the other would be holding the AIO in place, so probably the bottom fan).
The case has either two 120mm or two 140mm mounting holes in the front.
So, bottom line, this 140mm fan would be cooling the rad, in part, and giving extra out cooling for the case (on the part of the fan that goes out of the rad).
Would I lose a lot of performance on the AIO, with this setup? Not worth it?