- Jun 25, 2016
- 23
- 2
- 18,515
I had an old gigabyte geforce6100pm motherboard that stopped working. This was mostly for the kids so i tracked down a j&w 6100 mobo to replace it. Problem is with the frontpanel wiring. None of the wires are marked and the colors do not correspond with the coloring on the panelconnecter on the mobo.
Colors on the wires are
1 white
1 red
1 orange
1 blue
1 green
2 black(actually 1 wire that is split into 2 pins)
The mobo coloring are as follows (starting at top left, working like one would read)
Blue(with a plus)
Blue (solid)
Blue (solid)
Red (solid)
Red (with a plus)
Next line
Blank(no pin)
Black(solid)
Black(with a plus)
Green (solid)
Green (with a plus)
Any idea which wires should go where?
I have tried putting color by colour but then it switches on for 2 seconds before ahutting down again.
Colors on the wires are
1 white
1 red
1 orange
1 blue
1 green
2 black(actually 1 wire that is split into 2 pins)
The mobo coloring are as follows (starting at top left, working like one would read)
Blue(with a plus)
Blue (solid)
Blue (solid)
Red (solid)
Red (with a plus)
Next line
Blank(no pin)
Black(solid)
Black(with a plus)
Green (solid)
Green (with a plus)
Any idea which wires should go where?
I have tried putting color by colour but then it switches on for 2 seconds before ahutting down again.
Facebook
Twitter
Instagram