Is MY HDD on the Fritz

Ferimer

Distinguished
During Sleep mode There are times when i turn it back on and it starts rebooting and scan disk option appears, this rarely happens. I looked into logs and did a bunch of research, so I downloaded crystaldiskinfo. I am wondering if anyone is able to tell me if my HDD is fine or on the way out? Please and thank you. here are all non-zero values.
Read Error Rate - 1
Spin-Up Time- 2216
Start/Stop COunt- 2178
Power-On Hours- 7704
Power Cycle Count - 2163
Power-off Retract Count - 54
Load/Unload Cycle Count - 2135
Tempertaure - 34
Judging that the majority of these are power related and everything seems at a normal level i dont think its on the way out, but i just need to be sure. any and all help is greatly appreciated thanks again.
 

Ferimer

Distinguished


HD Tune Pro: WDC WD10EZEX-21M2NA0 Health

ID Current Worst ThresholdData Status
(01) Raw Read Error Rate 200 200 51 1 ok
(03) Spin Up Time 174 171 21 2266 ok
(04) Start/Stop Count 98 98 0 2201 ok
(05) Reallocated Sector Count 200 200 140 0 ok
(07) Seek Error Rate 200 200 0 0 ok
(09) Power On Hours Count 90 90 0 7871 ok
(0A) Spin Retry Count 100 100 0 0 ok
(0B) Calibration Retry Count 100 100 0 0 ok
(0C) Power Cycle Count 98 98 0 2182 ok
(C0) Unsafe Shutdown Count 200 200 0 58 ok
(C1) Load Cycle Count 200 200 0 2154 ok
(C2) Temperature 106 97 0 37 ok
(C4) Reallocated Event Count 200 200 0 0 ok
(C5) Current Pending Sector 200 200 0 0 ok
(C6) Offline Uncorrectable 200 200 0 0 ok
(C7) Interface CRC Error Count 200 200 0 0 ok
(C8) Write Error Rate 200 200 0 0 ok

Health Status : ok