Need Assistance with Computer not displaying

OG_GriffMeister

Reputable
Jul 31, 2017
11
0
4,510
Hi everyone,
A few months ago my computer suddenly stopped displaying so I checked cables (display & case) and checked the graphics card and nothing was broken or out of place (computer would turn on, but not display). I even tested the CPU in another compatible motherboard on another custom build computer and it booted up just fine. I then decided to check the motherboard and I noticed a few pins bent. So I then decided to buy a new motherboard. Once bought, I tested it again to no avail; would start up, but no display at all. Looking at the motherboard while powered on, I noticed the CPU led had a solid LED which means there was a problem with the CPU. I inspected the CPU and noticed little blemishes on it (presumed burn marks) so I bought a new CPU which I received today and I still have the same problem. While checking the motherboard I noticed the CPU led would flash for 2 seconds then switch the the RAM LED for 2 seconds, rinse and repeat. I've also tested one stick of RAM to no avail. So far I've bought a new motherboard, CPU, graphics card and new RAM. I've reset the CMOS battery, tried DVI, HDMI and VGA, googled all around to find nothing. I'm now really stumped to what it would be as I've tried everything. I would love some assistance.
Thanks
Edit: I also forgot to mention my cooler is missing two screws that are supposed to be mounted to the bracket on the motherboard and I only have 3 screws holding the board in place.

Specs
Old CPU: Intel Core i7 4820k
New CPU: Intel Core i7 6800k
Old motherboard: Asus Sabretooth x79
New motherboard: MSI X99a Tomahawk
Old graphics card: Geforce GTX 660 2gb
New graphics card: Geforce GTX 1070 8gb
Old RAM: Kingston 8gb (2x8gb)
New RAM: Corsair Vengeance (2x8gb)
PSU: Thermaltake 750W Toughpower Gold
CPU Cooler: Thermaltake Big Water Pro 720
 

OG_GriffMeister

Reputable
Jul 31, 2017
11
0
4,510


With this motherboard I haven't been able to find where the case speaker pins are located. Any chance you'd know the general location?
 

OG_GriffMeister

Reputable
Jul 31, 2017
11
0
4,510

Alright, so I took out the graphics card and inserted 1 stick and it booted up and after 10 seconds there was a 1 second beep followed by 2 half second beeps. It then started flashing between DRAM and CPU LED again but stopped until a solid LED for VGA (no graphics card) appeared. Looking at the debug code it showed "62" which means "installation of the PCH Runtime Services"
I then powered it off and put the graphics card back in and booted up. There were no beeps and no solid or flashing LEDs for the CPU or RAM. Now the code is sitting between 23 and 24 which I can only imagine is my CPU temperature.