I recently built a new gaming PC. Because of case limitations I had to either put the fans on the top or bottom of the radiator with one side above the actual internal of the case. I put the fans on top with a pull up configuration.
I would like to make sure I didn't need to use the washers in the long screws that I put through the fans and into the radiator.
The H115i I installed came with short screws and washers that were supposed to be used in unison. I just want to make sure I am good not using them because I didn't use that set of screws.
Thanks.
Also the case is the Be Quiet Pro 900. I could've moved the motherboard housing down, but that was a pain and I didn't feel like doing it.
I would like to make sure I didn't need to use the washers in the long screws that I put through the fans and into the radiator.
The H115i I installed came with short screws and washers that were supposed to be used in unison. I just want to make sure I am good not using them because I didn't use that set of screws.
Thanks.
Also the case is the Be Quiet Pro 900. I could've moved the motherboard housing down, but that was a pain and I didn't feel like doing it.