Are my custom loop temperatures too high?

UNKNOWN5

Prominent
Apr 5, 2017
20
0
520
Hi,
i recently built a custom watercooling loop for my i7 6700k using a 360 black ice nemisis rad, ekwb supremacy evo cpu block and ek d5 pump n res combo. Ascetically im really pleased but my idle temps seem pretty high to me, especially considering i have seen mini itx builds with the same cpu as mine and a graphics card with only a 240mm rad, so surely if that gets good temps then my temps should be great. but 38 degrees C idle doesnt seem all that and although i havent run a proper stress test yet temps have hit 80 when installing, im really not sure what it could be.
before you ask no i havent got any visible bubbles and have ran the loop on for a couple of days now to try and get rid of all the air from the loop. i have heard that sometimes the cpu block may not be sitting correctly but i would have to dismantle my loop (hard tubing) to do this and i would rather not unless there is a good chance that is the problem. Has anyone got any ideas to improve temps?
Thanks i really appreciate the help
 
G

Guest

Guest
Perhaps you haven't properly installed the thermal paste. But idle temps mean nothing, the sensors aren't precise at low temps, like less than 50C. Only over 50C do you start to see temps that make sense.
 

UNKNOWN5

Prominent
Apr 5, 2017
20
0
520
Thanks for the answer, i guess ill have to run a benchmark of some sort, if they still arnt too good ill see about reapplying the thermal paste